ONOSOKKIHandheld tachometerHT-6200The HT-6200 handheld tachometer is suitable for measuring the speed of gasoline engines, diesel engines, and electric and hybrid vehicle motors. The tachometer's measuring and display parts are integrated and work with a built-in battery. Depending on the measurement object and purpose, various external sensors can be purchased for use, such as VP-202/1220 engine speed sensor, IP-292/296 and IP-3000A/3100 ignition pulse sensor, OM-1200/1500 electromagnetic speed sensor, MP series electromagnetic speed sensor, and TTL logic circuit signal sensor to measure the speed of the selected object. The measurement results can be saved in the internal memory, up to 20 data can be saved. And the saved data can be easily confirmed and checked. It can support the measurement of multiple items such as speed (r/min, r/s), cumulative number of rotations (counter), rotation cycle (ms), circumferential speed (m/min), etc. At the same time, it is standardly equipped with two signal output functions: analog voltage signal (switchable with monitoring signal) and pulse signal. The analog voltage signal output can be used for data acquisition of data recorders, the monitoring signal output can be used to confirm the signal waveform of the sensor or connect to the FFT analyzer for spectrum analysis, and the pulse signal output can be used as the speed input signal of the FFT analyzer when performing speed tracking analysis. Speed measurement of electric vehicles and hybrid vehicles Corresponding sensors for speed measurement of gasoline engines and diesel engines The corresponding sensors can be selected according to the purpose of use Engine IP-292/296 Ignition pulse sensor IP-3000A/3100 Ignition pulse sensor OM-1200/1500 Electromagnetic speed sensor VP-202/1220 Engine speed sensor (vibration) Motor OM-1200/1500 Electromagnetic speed sensor General rotating object MP series electromagnetic speed sensor The memory can save up to 20 measurement data The extreme value holding function can indicate the maximum value and the minimum value in the measurement. It has 3 signal output functions Analog signal output Speed value signal (used for data acquisition and recording of speed signal) Monitor signal output The signal of the sensor is the signal after waveform processing (used for waveform confirmation and analysis) Pulse signal output The detected pulse signal (used for synchronization of speed signal)